Tuesday, March 1, 2011

Oakley Razor Blades Oakley New Razor Blades?

BEARING BEARING-rings-rings: TUTORIAL

Tutorial in notturna questa volta.
In questo periodo ogni ora entro mezzanotte è buona per lavorare!

Tagliare in dritto filo due quadrati di lino di 20cm x 20cm.
Disegnare su uno dei due quadrati di lino, centrato nel tessuto quadrato, il contorno del cuscino con gli angoli arrotondati.


Tagliare un pezzo di nastro di 1,20cm circa.
Appoggiare il nastro su questo segno tenendosi 0.5 cm within the profile and pin it as always following the profile until it closes.


Warning! In the corners rounded form with thick pleated ribbon.


Sewing to 0.5 cm from the inner edge of the tape (then going to sew over the design of the profile that is hidden under the tape).
This helps to stop the tape and remove the pins from work.




very careful in the corners.


The result is this. (You can click on the picture to enlarge.)


Turn everything upside down.


cut to 0.5 cm outside of the seam.


the corners cut in a zig zag.


other hand is like that.


To secure the rear overlay work, as in the photo, on the square of linen and pin it with pins.


Sewing just inside the existing seam, leaving a small opening is not sewn.


Finally folding and ironing. Before you fill
cotton wool, make a small sign at the two points where you want to stick faiths. Fill the bearing
cotton, close the opening with a small sub invisible. Sew the ribbons to the two faiths by taking both the tissue and pulling the point.

0 comments:

Post a Comment